Marshall 5 In-Dash Speedo and Tach, Black Dial, Step Bezel, 2053STP, 2054STP
We double check each gauge for correct operation before packing your order. This process includes putting signals to all gauges to verify correct operation. We verify no accessory items are missing (u-clamps, bulbs, senders etc). We photo document your order to ensure completeness. High quality gauge made in Orange County, CA USA. High-speed full sweep stepper motor movement. Programmable speedo with one-step easy calibration and 2 Trip meters. Tachometer works with 0.5, 1, 2, 3, 4, 5, and 6 PPR ignition systems. Works with hall effect senders, vehicle speed sensors (VSS) or GPS senders. White through-the-dial LED lighting for easy viewing at night. 3D glowing pointer for easy visibility at night. Case OD is 4-9/16″, Bezel OD is 5″ (Recommended panel hole size is 3.75). Made in the U. This item is made in California, USA. Is a sending unit included? A speedometer sending unit is not included. This speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions. Pulse range generated proportional to the vehicle speed. Signal with minimum 3V peak to peak signal – typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs. Output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm). If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender. If you need a hall effect sender we can add a FORD or GM/Mopar hall effect sender to your order for a nominal charge. The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) will work with this electric speedometer. This speedometer will also work with aftermarket GPS style senders (12V square wave signal). TERMS & CONDITIONS Standard terms and conditions apply to this item. See our terms and conditions here: Terms & Conditions.
Comments are closed.