C2 Redline 6 Gauge Set, 5 inch Speedo & Tach, Silver Bezels, 73-10 Ohm, 2378
C2 Redline 6-Gauge Set with 5 Speedo and Tachometer. 5 Electric Programmable Speedometer, 0-160 MPH. 5 Tachometer, 0-10,000 RPM. 2-1/16 Oil Pressure, 0-100 PSI with sender. 2-1/16 Water Temperature, 120-280F with sender. 2-1/16 Fuel Level Empty-Full, 73-10 Ohm input range (other ranges are available, see below for details). We double check each gauge for correct operation before packing your order. This process includes putting signals to all gauges to verify correct operation. We verify no accessory items are missing (u-clamps, bulbs, senders etc). We photo document your order to ensure completeness. High quality gauges made in Orange County, CA USA. High-speed full sweep stepper motor speedometer and tachometer. Short sweep electric 2-1/16 gauges (Volts, Oil Pressure, Water Temperature, Fuel Level). Electric programmable speedo with one-step easy calibration and 2 Trip meters. White through-the-dial LED lighting for easy viewing at night. 3D glowing pointer for easy visibility at night. Made in the U. This item is made in California, USA. Please allow 1-2 days for your item to be made before it ships. Matching Vac/Boost, Trans Temp, Oil Temp & Fuel Pressure Gauges Matching Vac/Boost, Transmission Temperature, Oil Temperature, and Fuel Pressure gauges are available for this gauge set. Are sending units included? The oil pressure and water temp sending units are included. The volts gauge does not require a sender. A fuel level sender is not included. Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions. Pulse range generated proportional to the vehicle speed. Signal with minimum 3V peak to peak signal – typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs. Output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm). If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender. Add a hall effect sender to your order. The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer. The tachometer does not require a sender – you get the signal from the coil (-) or other tach signal source i. ECU or Tach output on HEI or ignition box. See terms and conditions for this item here: Terms & Conditions. Check out our other gauge set listings including our C2 Blueline with cobalt blue accents, C2 Redline with red accents and full sweep electric SCX gauge sets. The item “C2 Redline 6 Gauge Set, 5 inch Speedo & Tach, Silver Bezels, 73-10 Ohm, 2378″ is in sale since Tuesday, October 8, 2019. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Gauges\Gauge Sets & Dash Panels”. The seller is “y2llc” and is located in Trabuco Canyon, California. This item can be shipped to United States, Canada, United Kingdom, Australia, Mexico, Germany, Japan, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.
- Surface Finish: Black
- Manufacturer Part Number: 2378
- Brand: Marshall Instruments
- Warranty: Yes
- Part Brand: Marshall Instruments
Comments are closed.